11979823 - Laserfiche WebLink

Home Browse Search

Septic Permit 555-22-002106-PRMT Page 2 of 2 Date P:t 4-#0:4 ISS @fi I014 W cn orkDespti;on R)DN-(50{}GA i ANK FOR NEW`RESTROOMS NOtADDtF,O AL EM sPLOYEES �.p ittrt' } ,% x7&fie CQEtd1t101'15 O �� 6 ' e •The pump and alarm must be wired on separate circuits in the control panel. Pump wiring must comply with applicable building, electrical,or other codes.An electrical permit and inspection from the Department of Consumer and Business Services, Building Codes Division,or the municipality with jurisdiction,is required for pump wiring installation. •Install the pump and system components in accordance with the approved pump curve and specifications. •An anti-buoyancy device is required for the septic tank(s)and must be installed as per the manufacturer installation guidelines. •A minimum 18-gauge,green jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. •Meet all required setbacks All tanks must be tested for watertightness and have a water-tight riser to the ground surface.Twenty-inch minimum diameter if less than 36-in deep.Thirty-inch minimum diameter if greater than 36-in deep. Maintain access to septic tank for pumping and service. Installation of this onsite wastewater treatment system has been determined to comply with the applicable requirements in Oregon Administrative Rules Chapter 340, Divisions 071 and 073 and the Conditions of Approval above. 1. In accordance with Oregon Revised Statute 454,665,this Certificate of Satisfactory Completion is issued as evidence of satisfactory completion of an onsite wastewater treatment system at the location identified above. 2. Issuance of this Certificate does not constitute a warranty or guarantee that this onsite wastewater treatment system will function indefinitely without failure.Conditions imposed as permit requirements continue for the life of the system. 3.The area of the initial and the identified replacement area must not be subjected to activity that is likely to adversely affect the soil or the functioning of the system.Such activities may include, but are not limited to,vehicular traffic, livestock, covering the area with asphalt or concrete,filling,cutting,or other soil modification activities. 4.This onsite wastewater treatment system that be connected to the facility referenced herein within 5 years of the issuance of this Certificate of Satisfactory Completion(CSC)or rules for authorization notices,alteration permits,or construction-installation permits as outlined in OAR 340-071-0160,340-071-0205,or 340-071-0210 apply, including payment of an additional fee. 5.This system must operate in compliance with OAR Chapter 340, Division 071 and must not create a public health hazard or pollute public waters. 6. Unless otherwise required by the agent,the system installer must backfill(cover)this system within 10 days after the issuance of this Certificate of Satisfactory Completion. System Inspection: No Operation of Law-7 Days Notice: No Pre-Cover Inspection Waived Per 340-071: Yes Comments: Pump and Alarm inspection Waived • ^ •Co ay _mpleted llnspecttnris .o�... Inspector Inspection Inspection Date Inspection Result Aidan Bammes 7999 Final Septic 11/22/2023 Approved Kimberlee Aldrich 7310 Pump/Alarm System 11/22/2023 Approved Robert Goodwin 7020 Pre-cover 05/23/2022 Approved eff— W10 14VC-- I er ee A dric � Onsite Wastewater‘De6c4V2 CALL BEFORE YOU DIG...ITS THE LAW ATTENTION:Oregon law requires you to follow rules adopted by the Oregon Utility Notification Center. Those rules are set forth by Oregon Administration Rules. You may obtain copies of the rules by calling the center.(Note:The telephone number for the Oregon Utility Notification Center is 1-800-332-2344.) 11/28/23: 1:00:50PM ONS_OnsiteCSC_pr