12014325 - Laserfiche WebLink

Home Browse Search

Onsite Permit 555-20-007841-PRMT Page 2 of 3 Schedule or track inspections at www.buildingpermits.oregon.gov Call or text the word "schedule" to 1-888-299-2821 use IVR Number:555082421690 Schedule using the Oregon ePermitting Inspection App, search"epermitting" in the app store lat",11911"Wiati* 3 rk^ 5t . 3� t F Special Requirements Stake out required: No Groundwater type: Permanent Groundwater depth: N/A Pump to drainfield reqd: Yes Filter fabric on top of drain media: N/A Other special rqmt: 12 inch capping fil silt loam or silty clay loam soils required for this cap, bring sample into inspector for approval Absolutely only install in the dry months of the year June to October per DEQ rule Conditions of approval This permit is for the installation of an Alternative Treatment Technology (ATT) system and is to be installed by a person certified by the system manufacturer in accordance with OAR 340-071-0600 and 0650. See Alternative Treatment Technology rules at OAR 340-071-0345. ATT treatment standard 2 required. The septic tank must be approved for use with the ATT system to be installed. In addition to the As-Built and Materials List, a Start-Up checklist from the ATT maintenance provider is required to Final this permit.The owner of an ATT system must maintain a contract with a maintenance provider certified by the manufacturer to inspect, adiust and maintain the onsite system. The maintenance provider must submit an annual report and annual evaluation fee. Dry soil installation only (June 1 — October 1 unless otherwise authorized by the agent). The system must be installed by a licensed and certified ATT installer All tanks must be tested for watertightness and have a water-tight riser to the ground surface. Twenty- inch minimum diameter if less than 36-in deep. Thirty-inch minimum diameter if greater than 36-in deep. Maintain access to septic tank for pumping and service. Vehicular traffic and livestock must be restricted from the system area. Meet all required setbacks The system must be installed in the area approved during the site evaluation and in accordance with the construction plan approved by the agent, including any changes made by the agent. The pump and alarm must be wired on separate circuits in the control panel. Pump wiring must comply with applicable building, electrical, or other codes. An electrical permit and inspection from the Department of Consumer and Business Services, Building Codes Division, or the municipality with jurisdiction, is required for pump wiring installation. Install the pump and system components in accordance with the approved pump curve and specifications. An anti-buoyancy device is required for the septic tank(s) and must be installed as per the manufacturer installation guidelines. A minimum 18-gauge, green-jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. 11/6/20:9:17:08AM Page 2 of 3 ONS_OnsitePermit_pr