12332358 - Laserfiche WebLink

Home Browse Search

Septic Permit 555-24-004158-PRMT Page 2 of 3 1/Ifo a riptiorr R REP t GE FAILINQSYSTE O BIlM SFat Atarikirir " tvQ[tX�lAOtt�Q Co�fd `� .�� S 7a ,a q:4d�^�f„I;�; ... ..�';;'., n..".�.,,,,.,v.�, . �..r -...��awe,�3.<`�. �.. .._ k �"'»� _ .,». --r°_ "� �'�_ ate •Capping fill rules at OAR 340-071-0265.Construction must occur in dry soil conditions between June 1 and October 1 unless otherwise approved by the agent.The cap material must be pre-approved by the agent prior to placement. Minimum 10-ft between edge of fill and trench. Drainfield area must be scarified.Contact between native soil and fill must be mixed.Final cap to be seeded and or landscaped to prevent erosion.Protect from livestock and vehicular traffic. •Serial distribution.The cap material must be evenly graded to a final depth of 16-inches over the drain media. •Dry soil installation only(June 1 —October 1 unless otherwise authorized by the agent). •The system must be installed by the property owner or a licensed sewage disposal business(installer). •Vehicular traffic and livestock must be restricted from the system area. •All roof drains must be directed away from the system •All tanks must be tested for watertightness and have a water-tight riser to the ground surface.Twenty-inch minimum diameter if less than 36-in deep.Thirty-inch minimum diameter if greater than 36-in deep. Maintain access to septic tank for pumping and service. •Meet all required setbacks •The system must be installed in the area approved during the site evaluation and in accordance with the construction plan approved by the agent,including any changes made by the agent. •All work is to conform to OAR 340, Division 71 and 73.Make no changes in system location or specifications without approval by the agent. •For product approval information and manufacturer installation requirements see DEQ website at: http://www.oregon.govideq/Residential/Pages/Onsite.aspx •The pump and alarm must be wired on separate circuits in the control panel. Pump wiring must comply with applicable building, electrical,or other codes.An electrical permit and inspection from the Department of Consumer and Business Services, Building Codes Division,or the municipality with jurisdiction,is required for pump wiring installation. •Install the pump and system components in accordance with the approved pump curve and specifications. •An anti-buoyancy device is required for the septic tank(s)and must be installed as per the manufacturer installation guidelines. •A minimum 18-gauge,green jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. •Header pipe from Distribution or Drop Box must be minimum 4-ft length,level,and bedded. •Each drainfield trench must be level within a tolerance of plus or minus 1-inch. •Maximum length of an individual trench is 150-feet. •Serial distribution,each trench bottom to be level and on contour.Use Drop box(es). Installation of this onsite wastewater treatment system has been determined to comply with the applicable requirements in Oregon Administrative Rules Chapter 340, Divisions 071 and 073 and the Conditions of Approval above. 1. In accordance with Oregon Revised Statute 454,665,this Certificate of Satisfactory Completion is issued as evidence of satisfactory completion of an onsite wastewater treatment system at the location identified above. 2. Issuance of this Certificate does not constitute a warranty or guarantee that this onsite wastewater treatment system will function indefinitely without failure.Conditions imposed as permit requirements continue for the life of the system. 3.The area of the initial and the identified replacement area must not be subjected to activity that is likely to adversely affect the soil or the functioning of the system.Such activities may include,but are not limited to,vehicular traffic, livestock, covering the area with asphalt or concrete,filling,cutting,or other soil modification activities. 4.This onsite wastewater treatment system that be connected to the facility referenced herein within 5 years of the issuance of this Certificate of Satisfactory Completion(CSC)or rules for authorization notices,alteration permits,or construction-installation permits as outlined in OAR 340-071-0160,340-071-0205,or 340-071-0210 apply, including payment of an additional fee. 5.This system must operate in compliance with OAR Chapter 340, Division 071 and must not create a public health hazard or pollute public waters. 6. Unless otherwise required by the agent,the system installer must backfill(cover)this system within 10 days after the issuance of this Certificate of Satisfactory Completion. CePfi, c f Satr��f ry Coeltpl�ttan h , . , °, System Inspection: Yes Operation of Law-7 Days Notice: No Pre-Cover Inspection Waived Per 340-071: No 8/12/24:1:14:05PM ONS_OnsiteCSC_pr