12382240 - Laserfiche WebLink

Home Browse Search

Onsite Permit 555-22-002725-PRMT Page 2 of 3 Schedule or track inspections at www.buildingpermits.oregon.gov Call or text the word "schedule" to 1-888-299-2821 use IVR Number:555074989574 Schedule using the Oregon ePermitting Inspection App, search"epermitting"in the app store Date issued T17122 �� 1=acptrafio►i`date ?17123' , a „ „x ,F -0 e w*_.. 447, Wark deI;g9pO FIRE MAJ REP 3 BbRM SFDfTO REPL 3 BDRM Seepage bed specs: 250 square feet(100 sf/150 gpd) Bottomless sand filter sqft: N/A laterals no more than 2 feet from sidewall and no more than 4 from each other. 1/8"orifices 2'spacing, install 1 downward orifice at end of each line for seasonal use/winter months. Media type: Rock/Pipe Media depth: 12 in. Trench length: N/A Rock above pipe: 2 in. Total rock depth: 12 in. Rock below pipe: 9 in. Max depth: 36 in. Undisturbed soil between trenches: N/A Min depth: 18 in. Capping fills-min depth of fill material: N/A Special Requirements • Pump to drainfield reqd: Yes Filter fabric on top of drain media: Yes Conditions of approval •This repair permit is for replacement of the existing septic system following the Beachie Creek Fire of 2020 which burned this property.This is a reasonable repair per OAR 340-71-0215(2)and HB 2289.A 25'setback to the escarpment is required. •Properly decommission the old septic tank and submit appropriate documentation. •The owner of an ATT system must maintain a contract with a maintenance provider certified by the manufacturer to inspect,adjust and maintain the onsite system.The maintenance provider must submit an annual report and annual evaluation fee. •The ATT system must be designed to prevent untreated waste from passing into the absorption field if the treatment system malfunctions. •In addition to the As-Built and Materials List, a Start-Up checklist from the ATT maintenance provider is required to Final this permit. Pressurized distribution rules at OAR 340-071-0275. Install sweep elbows at ends of lateral piping with acceptable threaded plugs or caps. Minimum head of 5-ft at remotest orifice, less than 10%variation. -All roof drains must be directed away from the system •All tanks must be tested for watertightness and have a water-tight riser to the ground surface.Twenty-inch minimum diameter if less than 36-in deep.Thirty-inch minimum diameter if greater than 36-in deep. Maintain access to septic tank for pumping and service. •The pump and alarm must be wired on separate circuits in the control panel. Pump wiring must comply with applicable building, electrical, or other codes.An electrical permit and inspection from the Department of Consumer and Business Services, Building Codes Division,or the municipality with jurisdiction, is required for pump wiring installation. •A minimum 18-gauge,green jacketed tracer wire or green color-coded metallic tape must be placed on top of the effluent sewer or pressure transport pipe from tank to drainfield. 7/7/22:7:58:17AM ONS_OnsitePermitpr