My WebLink
|
Help
|
About
|
Sign Out
Home
Browse
Search
Permit - 1267987
Images9
>
Public Works - Permits
>
Building
>
FOR PUBLIC VIEW ON INTERNET
>
COMPLETED FILES - INACTIVE
>
Old Files 5
>
Permit - 1267987
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
2/2/2011 2:29:37 PM
Creation date
9/2/2003 3:31:55 PM
Metadata
Fields
Template:
Permits
Permit Address
7878 BARBARA LN SE
Permit City
Aumsville
Permit Type
Permit
Permit Site Number
6740
Permit Doc Type
Permit Document
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
27
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
Show annotations
View images
View plain text
7878 Barbara Lane SE, Aumsville <br />August 20, 1991 <br />Page 1 <br /> <br />/~1 O~EGON <br />i~iil=lll COMMUNITY DEVELOPMENT <br /> <br />B~ilding Znspeotlon - Dwelling Plan Review <br /> <br />The attached plans have been reviewed for compliance with the State of Oregon <br />1990 Edition One and Two Family Dwelling Specialty Code. <br /> <br />Foundation plates shall be bolted to the foundation with minimum <br />1/2 inch diameter by 10 inch anchor bolts embedded at least 7 inches <br />into concrete or reinforced masonry and spaced not more than 6 feet <br />apart with a minimum of 2 bolts per piece with one bolt within 12 inches <br />of the end of each piece. Figure (R-303) <br /> <br />4x12 beams over garage doors are not adequate to carry the loads imposed <br />on them. 4x14 beams or equivalent would be the minimum size necessary. <br /> <br />Roof trusses are required to be designed by an Oregon registered <br />Bngineer or Architect. For trusses manufactured by an approved <br />fabrication plant, have the design and layout drawings available at the <br />construction site for the framing inspection. All job site cutting or <br />modification of the roof trusses shall be clearly shown in the <br />engineer's design calculations and drawings. If trusses are to be built <br />at the job site, submit the engineer's design and construction plans to <br />the Marion County Building Department prior to start of construction and <br />have the approved drawings available at the site for the framing <br />inspection. <br /> <br />Ail plywood, when designed to be exposed in outdoor applications shall <br />be of an exterior type, except that plywood roof sheathing exposed to <br />the underside may be of interior type with exterior glue. (R-703.1) <br /> <br />Approval as a result of this plan review or an inspection shall not be <br />construed to be an approval of a violation of the provisions of the dwelling <br />code or of other ordinances of the jurisdiction. Reviews or inspections <br />presuming to give authority to violate or cancel the provisions of the <br />dwelling code Or of other ordinances ef the jurisdiction shall not be valid. <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />
The URL can be used to link to this page
Your browser does not support the video tag.