Laserfiche WebLink
1Btzildin~ Codes Division <br /> <br />Oregon <br /> <br />1535 Edgewa~:er NW <br />Salem, OR 97310 <br />Telephone (503) 378-4133 <br />Fax (503) 378-2322 <br />TDD (503) 375-1358 <br /> <br />FEBRUARY 3, 1995 <br /> <br />DEPARTMENT OF <br /> <br />CONSUMER AND <br /> <br />BUSINESS SERVICES <br /> <br />SANDRA FREILINGER PLANS EXAMINER <br />MARION COUNTY BUILDING DEPARTMENT <br />285 CHURCH STREET NE ROOM 132 <br />SALEM OK 97301-3670 <br /> <br />RE: AWNINGS & CARPORTS <br /> <br />As we discussed over the phone, OAR 918-5104)30(3) does not prohibit the attachment of awnings or <br />carports m manufactured dwellings, but establishes conditions by which it can be done. The intent of this <br />rule, though not very clear, is to allow the attachment of awnings and carport~ to the sidewalls of <br />manufactured dwellings. <br /> <br />The proper attachment of an awning or carport should consist of the following: The awning or carport <br />rail should be attached with lag screws directly to each sidewall stud (studs are usually at 16" on center). <br />Attachment to the siding only is not acceptable and we do not recommend attaching rails to sidewall top <br />plates. The single i" top plates will easily split out from the lag screws and neither 1" or 2" manufactured <br />dwelling top plates are designed to transfer the roof live loads of the manufactured dwelling or the <br />awning/carport to the studs. To transfer the loads from the sidewall studs to the ground, the current rules <br />suggest perimeter pier blocking at 8' on centex. However with the increased weight ,of the newer <br />manufaclltred dwellings and the additional roof load from the awning/carport, 4' on center would be more <br />appropriate., All other attachments should be made according to the awning/carport manufacturer's <br />engineered plans~vith special attention paid to the top and bottom post connections and ground anchors. <br /> <br />Regazding your question of which takes precederu:e for the attachment of accessory structures to <br />manufactured dwellings (manufactured dwelling manufacturer's installation instructions v~. Oregon <br />Specialty Codes), the Oregon Specialty Codes take precedence. <br /> <br />Thank you for bringing this issue to my attention. We are currently in the process of re-writing the <br />manufactured dwelling rules and will attempt to make this section more clear and more "user friendly." <br /> <br />PATRICK D. LEWIS, Code Specialist <br />Code Development- and Compliance <br /> <br />PDL:mgi <br /> <br />cc: Don Dickey, Alumax <br /> <br /> <br />