12983376 - Laserfiche WebLink

Home Browse Search

System 4000 Surface Conditioner Sprayer The Bituthene System 4000 Surface ~t Conditioner Sprayer is a professional grade,polyethylene,pump-type• compressed air sprayer with a brass fan tip = •# nozzle. It has a 2 gal(7.6 L)capacity. 'Ihe nozzle orifice and spray pattern have been specifically engineered for the optimum application of Bituthene System 4000 Surface Conditioner. Hold nozzle 18 in. (450 ram)from Sprayer should not be used to store substrate and squeeze handle to spray. Bituthene System 4000 Surface Condi- Spray in a sweeping motion until substrate boner.The sprayer should be flushed with is uniformly covered. clean water immediately after spraying. Sprayer should be repressurized by For breaks in the spray operation of one pumping as needed. For best results, hour or less, invert the sprayer and squeeze sprayer should be maintained at high pres- the spray handle until only air comes from sure during spraying. the nozzle.This will avoid clogging. To release pressure, invert the sprayer and Should the sprayer need repairs or parts, spray until all compressed air is released, call the maintenance telephone number on Maintenance the sprayer tank(800-323-0620). The Bituthene System 4000 Surface Conditioner Sprayer should perform without trouble for an extended period if maintained properly. Bituthene System 4000 Surface Conditioner Membrane at least 21/4 in. (65 mm)onto is clear when dry and may be slightly tacky. deck membrane,and 21/4 in. (65 mm)onto In general,conditioning should be limited to wall membrane.Terminate top of wall what can be covered within 24 hours. In situa- flashing with Bituthene Mastic,Bituthene tions where long dry times may prevail, Liquid Membrane or termination bar. substrates may be conditioned in advance. Option 2:Apply membrane on deck to Substrates should be reconditioned if signifi- within 1 in. (25 mm)of corner.Treat the cant dirt or dust accumulates, inside corner by installing a%4 in. (20 mm) Before surface conditioner dries,tools should fillet of Bituthene Liquid Membrane. be cleaned with water.After surface condi- Extend Bituthene Liquid Membrane at least boner dries,tools should be cleaned with 21 in. (65 mm)onto wall. mineral spirits. Mineral spirits is a combustible Option 3: Apply membrane on deck to liquid which should be used only in actor- within 1 in. (25 mm)of corner.Treat the dance with manufacturer's recommendations. inside corner by installing a 1/4 in. (20 mm) Do not use solvents to clean hands or skin. fillet of Bituthene Liquid Membrane.Apply Corner Details membrane flashing sheet on wall,over fillet The treatment of corners varies depending on and 6 in. (150 mm)onto deck membrane. the location of the corner. For detailed infor- Apply 1 in. (25 mm)wide troweling of mation on Bituthene Liquid Membrane, see Bituthene Mastic or Bituthene Liquid separate product information sheet. Membrane over all terminations and seams • At plaza deck to wall inside corners— within 12 in. (300 mm)of corner. Terminate Option 1:Apply membrane on wall and top of wall flashing with mastic, Bituthene deck to within I in. (25 mm)of cornet Liquid Membrane or termination bar. Treat the inside corner by installing a'/4 in. (20 mm) fillet of Bituthene Liquid Membrane. Extend Bituthene Liquid