Laserfiche WebLink
41 <br /> 13.0 Interior Finishes <br /> For inside plaster application, follow the instructions of the manufacturer/supplier of the plaster <br /> mix. Where other materials join Faswall®Wallforms, and around doors and windows, a <br /> reinforcing fiber mesh should be applied. As in the stucco application, the base coat will require <br /> about 20% more material as used for conventional concrete walls. <br /> If there any doubts or questions, it is important to contact Faswall®before you proceed. <br /> 13.1 Interior Finishing of Faswallt Wallforms With Gypsum/Drywall Products <br /> Faswall®Wallforms present a solid surface to fasten to no matter what interior finish is selected <br /> for the interior surface of the wall. When applying drywall/Gypsum board, coarse threaded <br /> drywall screws are typically used to fasten to Faswall®Wallform. Different types of fasteners <br /> have correspondingly different pullout strengths. A#6 x 2" long coarse threaded drywall screw <br /> is adequate for hanging the board. The following caution and conditions need to be met when <br /> using standard#6 x 2" long coarse threaded drywall screws: <br /> Throughout the body of the interior drywall board the maximum spacing for fasteners is 12". <br /> liir Throughout the perimeter of the interior drywall board the maximum spacing for fasteners is 6". <br /> Use of construction adhesive that is compatible with the cement-based nature of Faswall® <br /> Wallform should be applied at the corners and center of the drywall <br /> board. Over-drilling into the Faswall®Wallforms composite can strip out the hole; a <br /> clutch drill is recommended to avoid this action. <br /> ShelterWorks General Application and Technical Information (GATI)version 2.5 <br />