Laserfiche WebLink
LOCATION OF SHOWER CONTROLS FOR ACCESSIBLE STANDARD ROLL-IN SHOWERS <br /> DISCREPANCY BETWEEN OSSC(ANSI)AND ADA(ADAAG) <br /> illir <br /> FROM ANSI A117.1 2009: <br /> 608.4.2 Standard Roll-In Showers.In standard roll- <br /> to shovers, the contrcls and hand shower shalt be <br /> located on the back wall above the grab bar, 48 r <br /> inches(1220 irn)maximum above the shower Coot <br /> and 16 inches (405 rrpn) min:mete and 27 inches 1 <br /> (685 mm) maximum fsom the end wall behind the <br /> seat. <br /> �685 <br /> Sam <br /> 405 <br /> back w 2 —. <br /> ststre <br /> a. Z I <br /> f 9 <br /> 7 ,fili <br /> / With Seat <br /> CY PG.SOME <br /> STANDARD ROLL4N-TYRE SHOWER <br /> CONTROL AND HAHDSNOWER LOCAIIDN <br /> FROM ADA 2010,WHICH REFERENCES ADAAG 2004: <br /> 608.5.2 Standard Roll-In Type Shower Compartments.In standard roll-in type shower compartments,the controls, <br /> faucets,and shower spray unit shall be located above the grab bar,but no higher than 48 Inches(1220 mm)above the <br /> shower floor.Where a seat Is provided,the controls,faucets,and shower spray unit shall be Installed on the back wall <br /> adjacent to the seat wall and shallTbe located 27 Inches(685 mm)maximum from the seat wall. <br /> /j1P R <br /> -can be located on <br /> /aaannywwwllashower ]]maxirF.2.snit <br /> R d E <br /> (a) (6) <br /> vnmeut seat with seat <br /> 411, <br /> Figure 608.5.2 Standard Roll-In Type Shower Compartment Control Location <br />