13001433 - Laserfiche WebLink

Home Browse Search

• CORNERSTONE FOUNDATION SYSTEM LLC thy 140 Art Mill Lane,Roseburg Or. 97471 (541)733-5441 PATENT NO. US. 9,109,355 B SMART FOUNDATION RR-54,S-60 AND IS-60 INSTALLATION INSTRUCTIONS • Cut bottom of panel to height,space for wedges at bottom of panel not to exceed 1". • Install top and bottom conru for into precast panel.Four top and four bottom holes arc cast in panel,pre drill holes when needed. Install connector plates facing outside or inside of wall panel. *See Poured in Place Footing Installation Instructions • Install vent panels on left and right side of corner,each vent is 72 square inches.All other panels arc without vents,work from corner to center of wall or behind doorstep for last panel cut to fit. • Move panel in position with pry bar, Iiii snug to rim joist. Drive wedges finn,do not over tighten. may cause home to lift off of piers. *See Wedge Set Placement • Confirm foundation wall is straight and plumb before driving screws into joist and footing. Connectors Outside of Wall-Set the face of the panel back :6' from the face of the rim joist. Drivejoist screw at slight angle for maximum bite. *See Connectors Inside&Outside Wall Connectors Inside of Wall-Set the face of the panel Y"out from the face of the rim joist,basically to the face of the exterior siding. Drivejoist screw at slight angle for maximum him. *Sec Poured in Place Footing Installation Instructions and Connectors Inside& Outside Mill • Seal all vertical seams with caulking. Send gap at bottom of panel to footing with non-shrink mortar.When back filling more than 8". add moisture hairier solution to mix.ACT ERNAFE FOOTING PC-48 minimum 6",back fill on wall,concrete grout seal not required. • Partial precast wall panels twelve inches or wider must have two(2)top and two(2) bottom connectors. Pre drill 3/16"as needed.Minimum 3" from side edge of wall panel spaced evenly. • All pier supports under the main-frame and marriage line shall be installed according to Model Manufactured Home Installation Standards andJor authorities having jurisdiction. It is the responsibility of the contractor or person(s)drawing permit to comply with Model Manufactured Home Installation Standards- Installer must comply with footing frost depth according to Model Manufactured Home Installation Standards. ATTENTION TO CONTRACTOR AND HOMEOWNER • Cornerstone Foundation System is designed to fit tight to the rim joist and sealed at the footing to prevent the entrance of rodents to the underside of home. Do not allow holes larger than '4" to be left open by installer of phone,TV cable,air conditioning lines, water gas etc. • Soil back fill-keep load of tractor away from foundation wall. Do not push against wall with tractor. ?Ito2 � f1I tu .; Q lchr.. Revisal Oct.2017 asrth tl p \a � ; Page 10 of 13 v .� FAT s �-'1-cJ,{�