13006975 - Laserfiche WebLink

Home Browse Search

• CORNERSTONE FOUNDATION SYSTEM LLC 140 Art Mill Lane, Roseburg, Or. 97471 Co (541) 733-5441 PATENT NO. US. 9,109,355 Ell SMART FOUNDATION RB-54, S-60 AND LS-60 INSTALLATION INSTRUCTIONS • Cut bottom of panel to height, space for wedges at bottom of panel not to exceed I". • Install top and bottom connector into precast panel. Four top and four bottom holes arc cast in panel, pre drill holes when needed. Install connector plates facing outside or inside of wall panel. 'See Poured in Place Footing Installation Instructions • Install vent panels on lefi and right side of corner,each vent is 72 square inches.All other panels are without vents,work from corner to center of wall or behind doorstep for last panel cut to fit. • Move panel in position with pry bar, lilt snug to rim joist. Drive wedges firm,do not over tighten, may cause home to liti otT of piers. 'See Wedge Set Placement • Confirm foundation wall is straight and plumb before driving screws into joist and footing. Connectors Outside of Wall-Set the lace or the panel back %" from the face of the rim joist. Drive joist screw at slight angle for maximum bite. `See Connectors Inside& Outside Will Connectors Inside of Wall-Set the race of the panel '/:"out from the face of the rim joist,basically to the face of the exterior siding. Drive joist screw at slight angle for maximum bite. '.See Poured in Place Footing Installation Instructions and Connectors Inside& Outside Mill • Seal all vertical seams with caulking. Seal gap at bottom of panel to footing with non-shrink mortar. When back filling more than 8",add moisture bather solution to mix.ACTERNATF. FOOTING PC-48 minimum 6",back till on wall,concrete grout seal not required. • Partial precast wall panels twelve inches or wider moil have two(2)top and two(2)bottom connectors,Pre drill 3/16"as needed. Minimum 3" from side edge of wall panel spaced evenly. • All pier supports under the main-frame and marriage line shall be installed according to Model Manufactured Home Installation Standards and/or authorities having jurisdiction. It is the responsibility of the contractor or person(s)drawing permit to comply with Model Manufactured Home Installation Standards.Installer must comply with footing frost depth according to Model Manufactured Home Installation Standards_ ATTENTION TO CONTRACTOR AM)HOMEOWNER • Cornerstone Foundation System is designed to fit tight to the rim joist and sealed at the footing to prevent the entrance of rodents to the underside of home. Do not allow holes larger than t4" to be left open by installer of phone,TV cable,air conditioning lines, water gas etc. • Soil back fill - keep load of tractor away from foundation wall. Do not push against wall with tractor. tr vlC l tfive,. v {re)Zr_t r �lr s— tAr.,,1h 1 „eyf:�eS tt r1. >b 9 C Revised Oct.2017 -Pr *rrh210 �- ifylS FtStOA t tyi,�' r t Page 9 EXPIRES 1 '-. 1-e)