Laserfiche WebLink
Backstop NT For Use Beneath Claddings Other Than Dryvit EIFS DS806 <br /> • All opening terminations, Sto rage • Shall not be used below grade or <br /> roof/wall intersections, Backstop NT must be stored at a on surfaces that will be <br /> transitions between different minimum of 40 °F (4 °C)and a subjected to water immersion. <br /> materials, chimneys, decks, roof, maximum of 100 °F (38 °C) in • Shall not be used to treat holes <br /> windows,etc., must be properly tightly sealed containers protected or sheathing joints exceeding <br /> flashed,wrapped and sealed as from weather and out of direct 1/4 in (6.4 mm). <br /> required by the building code, sunlight. • When used beneath Portland <br /> good construction practice cement stucco or adhered stone <br /> and/or Dryvit Backstop NT Cautions and Limitations products, paper backed lath shall <br /> Application Instructions For Use • Avoid applying Backstop NT in be installed over Backstop NT as <br /> Beneath Claddings Other Than direct sunlight. Always work on a slip sheet. <br /> Dryvit EIFS, DS300. the shady side of the wall or • Backstop NT can be exposed to <br /> protect the area with appropriate weather up to 180 days to <br /> Mixing shading material. provide sufficient time for <br /> Material is ready for use after an • Apply to acceptable substrates installation of the cladding. <br /> initial spin-up using a drill with only. Inspect the surface of the <br /> paddle mixer. DO NOT ADD • OSB-Application over Oriented Backstop NT for any damage, <br /> CEMENT, Strand Board (OSB) requires a cracks, voids or other <br /> minimum of 2 coats of detrimental conditions and repair <br /> Backstop NT Application Backstop NT-Smooth or Spray. prior to installation of the <br /> Refer to the usage/application Backstop NT-Texture is not cladding. <br /> chart for the appropriate use and recommended for use in the field <br /> application technique for a given of OSB. Technical and Field Services <br /> substrate. • CMU-Application over unpainted Available on request. <br /> concrete and CMU requires one of <br /> Clean Up the following: <br /> Clean tools with water while material a.Two coats of Backstop NT- <br /> is still wet. Texture, spray or roller-applied. <br /> b.Two coats of Backstop NT- <br /> Spray. <br /> c.One coat of Backstop NT- <br /> Texture, trowel applied. <br /> c <br /> 2 <br />