Laserfiche WebLink
QQW-14-A <br /> Page 2 <br /> B.Applicators shall have a minimum of 5 years, experience in application of waterproofing materials of the type <br /> specified. Applicator shall possess a current"Qualified Applicator"Certificate from specified waterproofing <br /> 4100 manufacturer. <br /> C. Pre-Bid Conference: 10 working days prior to bid opening there is to be a mandatory Pre-Bid Conference. Anyone <br /> not attending the Pre-Bid Conference will not be allowed to bid the project. All products considered an equal to the <br /> specified product or any changes in the scope of work installation or specifications must be presented at the Pre-Bid <br /> Conference. If a change in the specifications is accepted, it will be considered as an alternate and will be presented <br /> as a bid amendment issued 5 working days prior to the bid opening. No other changes to specification or bid <br /> documents will be accepted. <br /> D. Pre-Installation Conference: Just prior to commencement of fluid application waterproofing system, meet at site with <br /> representative of coating manufacturer,waterproofing contractor, general contractor, architect and other parties <br /> affected by this section. Review methods and procedures, substrate conditions, scheduling and safety. <br /> E. The static coefficient shall exceed the minimum recommendations of the American Disability Act(ADA), for <br /> accessible routes,for wet and dry surfaces, and for leather and rubber heel materials. <br /> 1.5 DELIVERY, STORAGE AND HANDLING <br /> A. Store all coating materials in original unopened containers at 60°to 80°F (16°to 27°C) until ready to use. <br /> B. Follow the special handling or storage requirements of manufacturer for cold weather, hot weather, etc. <br /> C. Safety: Refer to all applicable data, including, but not limited to MSDS, PDS, product labels and instructions for <br /> personal protection requirements. <br /> D. Ventilation: General room ventilation is satisfactory. <br /> [ <br /> w E. Environmental requirements: Proceed with work of this section only when existing and forecasted weather conditions <br /> will permit the application to be performed in accordance with manufacturer's recommendations. <br /> 1.6 JOB CONDITIONS: <br /> A. Safety: Refer to all applicable data, including, but not limited to MSDS, PDS, product labels and specific instructions <br /> for specific personal protection requirements. <br /> B. Ventilation: Provide adequate ventilation to prevent the accumulation of hazardous fumes during application. <br /> C.Weather: Proceed with the work of this section only when existing and forecasted weather conditions will permit the <br /> application to be performed in accordance with the manufacturer's recommendations. <br /> 1.7 WARRANTY <br /> A warranty is available for commercial projects only. Contractor must be eligible for and make application to Gaco <br /> Western LLC, prior to the start of the work under this section. <br /> PART 2-PRODUCTS <br /> 2.1 MANUFACTURERS <br /> Acceptable Manufacturers: <br /> Gaco Western, LLC www.gaco.com <br /> 2.2 MATERIALS <br /> Lits/ A. Acrylic Coating: GacoFlex A-38 Acrylic Series Coatings. <br /> B. Granule: GacoShell Granule, a hard(90 Rockwell Scale), non-crushable, non-extractable organic granule with a <br /> specific gravity of 1.3. Size 40/60 unless otherwise specified. <br /> Made in the USA • gaco.com • 800.331.0196 <br />