MANF - 1465253 - Laserfiche WebLink

Home Browse Search

MARION COUNTY BUILDING INSPECTION COMMUNITY DEVELOPMENT CENTER 285 Church Street NE · Room 132 · Salem, Oregon 97301-3670 Office Hours: 8:00-4:30 · Phone: (503) 588-5147 · 24-HR Inspection Line: (503) 373-4427 DATE/TIHE TYPE OCCUPANCY H~JUF~CTURED DWELLINg PERflIT : e4/~8/97 11:1e PEP. HIT NO : 97-81837 : HeN Hanufactured DNeZling STATUS : ISSUED : R-3 ISSUED : B4/88/1997 TS EXPIRE ~ 18/85/1977 PAGE 3 Manufactured dwelling readx for occupancy. Assigned street numbers shall be pe~nted or affixed to the front of the dwelling [na contrasting and highly visible color, not less than four (4) inches in height. This inspection includes checking construction and code requirements for decks and steps~ skirting and underfloor ventilation and access. A REINSPECTION FEE OF $68.88 shall be assessed for each inspection bexond the permitted three inspections or (1) when the permit card is not posted on the job site~ (2) for failure to provide access on the date for which the inspection is requested; (3) when the work for which an inspection is requested is not complete, ~4) when the Manufactured dwelling is not installed per 1~6 Hanufactur'ed Dwelling Standards; (5) for failing to attach an installer~s certification tag, or (6) when required corrections are not' made. No inspections will be perforMeB until the reinspection fee has been paid at our office. OTHER CUMMEN1S AND CUHDIIlON5 ~. THIS PLAN REVIEW WAS COMPLETE~ BY DWALTERS ON 4/2/77. 1996 CODE. 2. Approval of submitted plans is not an approval of omissions or oversights by this office or of noncompliance with any applicable regulations of local 9over~Meot. 3. A roadside marker shall be placed at the access point with address numbers in a contrasting and hiqhly visible color, not less than three (3) inches [n heiqht. 4. Site grading and drainage shall provide grades which slope downward away f~oM manufactured dwelling stands, foundation footinqs, concrete slabs, patios~ walls, skirtinq, and. foundations at a HINIHUH GRADE OF 1/2 INCH PER FOOT FOR ~ FEET horizontally. (Section 302(c) 1~76 Oregon Manufactured Dwelling Code Standards). 5. Provide at least I square foot of underfloor ventilation for each 150 square feet of crawl space area. The openinqs shall be covered with a corrosion resistant wire Mesh. Al least one such openin~ shall be provided within 3 feet of each corner of the bu[ldinq. (R-311.1) 4. Provide an access crawl hole to the underfloor space. The MiniMum size opening required is 18 inches by 24 inches. (R-311.2) 7. Stairways shall not be less than 3 feet in clear width and the headrOoM shall not he less than 6 feet 8 inches. The MiniMuM required stair tread width is 9 inches. The MaxiMum stair rise is 8 inches. When risers are closed~ all treads may have a uniform projection not to exceed 1 and 1/2 inches. The greatest riser heiqht shall not exceed the smallest by More than 3/8 inch. 1R-213.1) 8. Handrails Meeting the following reguireMents shall be provided on at least one side of s~airways. Tbe hand,rip portion of handrails shall be not More than 2 5/8 inches in cross-sectional dimension, or the shape shall provide an equivalent gripping surface. Handrails shall be mounted between a M~niMuM of ~0 inches and a MaxiMuM Of ~8 inches. They shall be continuous the full length of the stairs. Ends shall be returned or shall terminate in newel posts or safety terMinals. (R-71~.1) 9. A M~.niMuM ~' X ~' landing shall be required on each side of an egress door. The floor or* landing shall not be More than one and one-half inches lower than the top of the tbr'eshold. (R-212) Exception: The landing on the exterior side of an exterior doorway ~hall not be More than 8 and 1/4 inches below the top of the threshold. 10. Pore:has, balconies or raised floor surfaces located More than 30 in. above the floor or grade shall have guardrail not less than ~& inches in height. Required guarBrail shall