MANF - 1501621 - Laserfiche WebLink

Home Browse Search

MANUFACTURED DWELLING PERMIT DATE/TIM~ : 04/09/98 14:14 PERMIT NO TYPE : Not in table. STATUS UGB: SITE: FD ISSUED TO EXPIRE PAGE 98-02586 ISSUED 04/09/1998 10/06/1998 2 PlAN REVIEW COMMENTS AND CONDITIONS REQUIRED S~BACKS: Front: 20 Left: 20 Right: 20 Rear: 20 Special This is a plan review covering the installation of the manufactured dwelling and is to be used for single family dwelling purposes only, This review does not include any review of accessory structures. Separate permits are required for accessory structures, including garages and carports, electrical service, water lines, sewer lines, and septic systems. The approved site plan shall be posted in a visible and readily accessible location prior to the inspection request. The manufactured dwelling is to be installed per the 1997 Oregon Manufactured Dwelling Standards. The permit fee for this manufactured dwelling covers a maximum of three inspections, (1) STAND inspection, prior to the installation of the manufactured dwelling; (2) INSTALLATION inspection (Footings/Setbacks/Blocking and Connections): and (3) FINAL inspection. All blocking, installation of temporary or permanent stairs and plumbing, electrical, and mechanical conections are required prior to an inspection requst. A REINSPECTION FEE OF $60,00 shall be assessed for each inspection beyond the permitted three inspections or (1) when the permit card or the approved site plan is not posted on the job site; (2) for failure to provide access on the date for which the inspection is requested; (2) when the w~rk for which an inspection is requested is not complete. (4) when the manufactured dwelling is not installed per 1997 Manufactured Dwelling Standards; (5) for failing to attach an installer's certification tag, or (6) when required corrections are not made, No inspections will be performed until the reinspection fee has been paid at our off~ce. U~HLM CC~qMENTS AND CUNDI~IUNS 1, THIS PLAN REVIEW W/LS COMPLETED BY R,STEWART ON 4-8-98. 2. Approval of submitted plans is not an approval of omissions or oversights by this office or of noncompliance with any applicable regulations of local government. 2. Site grading and drainage shall provide grades which slope downward away from manufactured dwelling stands, foundation footings, concrete slabs, patios, walls, skirting, and foundations at a MINIMUM GP~ADE OF 1/2 INCH PER FOOT FOR 6 FEET horizontally, (Section 302(c) 1996 Oregon Manufactured Dwelling Code Standards). 4. Provide at least 1 square foot of underfloor ventilation for each 150 square feet of crawl space area. The openings shall be covered with a corrosion resistant wire mesh. At least one such opening shall be provided within 3 feet of each corner of the building. (R-211,1) 5, Provide an access crawl hole to the underfloor space, The minimum size opening required is 18 inches by 24 inches, (R-311.2) 6, Stairways shall not be less than 3 feet in clear width and the headroom shall not be less than 6 feet 8 inches. The minimum required stair tread width is 9 inches, The maximum stair rise is 8 inches. When risers are closed, all treads may have a uniform projection not to exceed 1 and 1/2 inches. The greatest riser height shall not exceed the smallest by more than 3/8 inch, (R-213,1) 7. Handrails meeting the following requirements shall be provided on at least one side of stairways. The handgrip portion of handrails shall be not more than 2 5/8 inches in cross-sectional dimension, or the shape shall provide an equivalent gripping surface, Handrails shall be mounted between a minimum of 30 inches and a maximum of 38 inches, They shall be continuous the full length of the stairs, Ends shall be returned or shall terminate in newel posts or safety terminals,