Laserfiche WebLink
INSERT:] Provide building xVAC aystema consistent with <br />standards set forth in ANSI/ASHRAE 62-1989 and Addendum <br />62a-1990, "Ventilation for Acceptable Indoor Air Quality".j <br />PART 3 EXECUTION <br />WASTE MANAGEMENT <br />A. Separate and recycle cut-offs and waste materials in <br />accordance with the Waste Management Plan and to the maximum <br />extent economically feasible. <br />s. Place materials defined as hazardous or toxic waste in <br />designated containers. <br />C. Return solvent and oil aoaked rags for contaminant <br />recovery and laundering or for proper dispoeal. <br />D. Use trigger operated spray nozzles for water hoaes. <br />E. use the least toxic sealants, adhesives, lubricanta, <br />sealers, and finishes necessary to comply with the <br />requirements of thia section. <br />F. close and seal tightly all partly used sealant and <br />adhesive containers and store protected in well ventilated <br />fire-safe area at moderate temperature. <br />G. Place used sealant and adhesive tubes and containers <br />in areas designated for hazardous waste. <br />SPECIFIC SECTIONS <br />[SECTIONS WITH SIMILAR WASTE CHARACTERISTICS ARE SHOWN GROUPED. <br />INSERT ADDITIONAL PROVISIONS UNDER PART 3 EXECUTION, WASTE <br />MANAGEMENT~ UNLESS OTHERWISE NOTED.] <br />15050 BASIC MECHANICAL MATERIALS AND METHODS <br />15400 PLUMBING <br />15500 HEATING, VENTILATING, AND AIR CONDITIONING <br />(THESE SECTIONS ARE APPROPRIATE LOCATIONS FOR TAE PROVISIONS <br />LISTED ABOVE WHEN MORE SPECIFIC SECTIONS ARE NOT USED.] <br />END OF DIVISION <br />