Laserfiche WebLink
11769 Warbler Lane NE, Aurora <br />93-02490 <br />September 2, 1993 <br />Page 1 <br /> <br />Mario,n County <br /> OR£GON <br />COMMUNITY DEVELOPMENT <br />E)E PA R'I'MENT <br /> <br />Building InSpection - Dwelling Plan Review <br /> <br />The attached plans have been reviewed for compliance with the State of Oregon <br />1990 Edition One and Two Pamily Dwelling Specialty Code. <br /> <br />The submitted plans are NOT ACCEPTABLE as they do not comply with code and <br />design requirements for this type of structure. Revise your plans or design <br />showing compliance with cede requirements and resubmit for review. <br /> <br />In response to your phone conversation and letter, Marion County Suilding <br />Inspection Department is not in the building design business. We do not <br />design buildings. <br /> <br />The plan review fee of $25.03 is for a review of your structural plans and <br />design calculations for code compliance. State statute requires that the <br />plans be reviewed by a State certified plans exsminer, which it was. A review <br />by an engineer has indicated that the plan is not approved as a free-stand~n~ <br />structure. <br /> <br />The proposed structure does not comply with conventional framing methods <br />outlined in the code and does not provide any lateral wall bracing as <br />required to resist lateral wind pressures, uplift and bending stress <br />caused bY the wind load. <br /> <br />The metal roof and decorative supports on one side which are proposed <br />for part of the carport support is a listed product that if installed <br />per the listing and attached to an existing structure which will provide <br />some lateral wall bracing. <br /> <br />When a proposed structure does not' comply with code requirements, the <br />applicant may design or hire someone to design his proposed structure. <br />The person designing the building is responsible to provide sufficient <br />information (plans and design calculations) to the building department <br />which show that the design complies with all building code requirements. <br /> <br />Exterior and foundation wall panels of frame construct£'on shall be <br />braced wi~h approved structural sheathing or 1-inch by 4-inch let in <br />braces. Structural sheathing and 1-inch by 4-inch let-in braces shall be <br />installed as per Table No. R-402.10, see the top of the next page fer a <br />copy of thi~ table. (R-402.10) <br /> <br /> <br />