My WebLink
|
Help
|
About
|
Sign Out
Home
Browse
Search
Permit - 1290481
Images9
>
Public Works - Permits
>
Building
>
FOR PUBLIC VIEW ON INTERNET
>
COMPLETED FILES - INACTIVE
>
95-XXXXX
>
Permit - 1290481
Metadata
Thumbnails
Annotations
Entry Properties
Last modified
4/4/2011 10:59:41 AM
Creation date
9/4/2003 10:05:37 AM
Metadata
Fields
Template:
Permits
Permit Address
520 8TH ST
Permit City
Aumsville
Permit Number
95-00011
Permit Type
Permit
Permit Doc Type
Permit Document
There are no annotations on this page.
Document management portal powered by Laserfiche WebLink 9 © 1998-2015
Laserfiche.
All rights reserved.
/
16
PDF
Print
Pages to print
Enter page numbers and/or page ranges separated by commas. For example, 1,3,5-12.
After downloading, print the document using a PDF reader (e.g. Adobe Reader).
Show annotations
View images
View plain text
520 8TH ST, AUMSVILLE <br />94-04677 (60267) <br />January 4, 1995 <br />Page 1 <br /> <br />Marion County '" <br />OREGON :,. · ~ <br />COMMUNITY OEV£LOPM[~NT <br />DE pAP.,TMENT <br /> <br />Building Inspection - Dwelling Plan Review <br /> <br />The at%ached plans have been reviewed for compliance with the State of Oregon <br />1993 Edition One and Two Family Dwelling Specialty Code. <br /> <br />A COPY OF THE APPROVED PLANS SHALL BE KEPT ON THE SITE OF THE BUILDING <br />OR WORK AT THE TIME OF THE INSPECTION. (R-111.2) <br /> <br />The grade away from foundation walls shall fall a minimum of 6 in. <br />within the first 10 ft., except as restricted by lot lines where the <br />fall will be a minimum of 6 in. regardless of the horizontal distance <br />available. (R-301.3) <br /> <br />When reinforcement is located in the footing in the proximity of the <br />electrical service panel, one piece of the reinforcement shall ex~end a <br />minimum of 1' above the plate to act as a grounding electrode for the <br />panel. If a piece is bent and tied, it must be tied (MINIMUM 1' LAP) to <br />a minimum 20' long section of reinforcement in the footing or wall. <br />Contact the Electrical Inspector with questions. (NEC Article 250- <br />Si(c)) <br /> <br />A keyway in the footing is an acceptable method and will transfer the <br />lateral loads, OR provide a 18 inch long NO. 3 dowels extending 12 <br />inches from the footing into the wall, 4 feet on center, OR pour the <br />footing and stemwall at one time (monolithically). All wood left <br />permanently in contact with the foundation shall be FOUNDATION GRADE <br />WITH nT.?. CUT ENDS AND/OR SIDES T~EATED with an approved wood <br />preservative. (R-310) <br /> <br />This foundation is being reviewed assuming 4 feet of unbalanced fill or <br />less. If the actual height of fill will be more than 4 feet, then an <br />ADDENDUM to this plan review shall be made by the permit holder, by <br />submitting to this office revised foundation plans showing the true fill <br />height befo~ construction commences. <br /> <br />Every sleeping room shall have at least one operable window approved for <br />emergency egress or rescue. The window sill height shall not be more <br />than 44 inches above the floor. The minimum net clear opening width <br />dimension shall be 20 inches. The minimum net opening height shall be <br />24 inches. The minimum net clear opening area shall be at least 5.7 <br />square feet. (R-210.2) <br /> <br />Individual glazed areas in hazardous locations shall pass the test <br />(CPSC 16-CFR) requirements of Section R-208.3 (safety glazing). <br />Hazardous locations are considered as follows: <br />a. In doors and within 24 inches of a door. <br /> <br />"APPROVED" only when this sheet is attached to plans <br /> <br /> <br />
The URL can be used to link to this page
Your browser does not support the video tag.