Laserfiche WebLink
DATE/TIME <br />TYPE <br />UGB: <br /> <br /> MANUFACTURED DWELLING PERMIT <br /> : 09/10/98 15:26 PERMIT NO <br /> : New Manufactured Dwelling STATUS <br />SITE: ISSUED <br /> TO EXPIRE <br /> PAGE <br /> <br />98-05227 <br />ISSUED <br />09/18/1998 <br />03/17/1999 <br />2 <br /> <br /> PLAN REVIEW COMMENTS AND CONDITIONS <br /> <br />REQUIRED SETBACKS: Front: 20 Left: 10 Right: 70 Rear: 20 Special: <br /> <br /> 70' MIN TO CENTERLINE OF ROAD <br /> <br />This is a plan review covering the installation of the manufactured dwelling and is <br />to be used for single family dwelling purposes only. This review does not include <br />any review of accessory structures. <br /> <br />Separate permits are required for accessory structures, including garages and <br />carports, electrical service, water lines, sewer lines, and septic systems, <br /> <br />The approved site plan shall be posted in a visible and readily accessible <br />location prior to the inspectqon request, Themanufactured dwelling is to be <br />installed per the 1997 Oregon Manufactured Dwelling Standards. <br /> <br />The permit fee for this manufactured dwelling covers a maximum of three inspections. <br />(1) STAND inspection, prior to the installation of the manufactured dwelling; <br />(2) INSTALLATION inspection (Footings/Setbacks/Blocking and Connections); and <br />(3) FINAL inspection, All blocking, installation of temporary or permanent <br />stairs and plumbing, electrical, and mechanical conections are required prior <br />to an inspection requst. <br /> <br />A REINSPECTION FEE OF $60.00 shall be assessed for each inspection beyond the <br />permitted three inspections or (1) when the permit card or the approved site plan <br />is not posted on the job site; (2) for failure to provide access on the date for <br />which the inspection is requested; (2) when the work for which an inspection is <br />requested is not complete, (4) when the manufactured dwelling is not installed <br />per 1997 Manufactured Dwelling Standards; (5) for failing to attach an installer's <br />certification tag, or (6) when required corrections are not made. No inspections <br />will be performed until the reinspection fee has been paid at our office, <br /> <br /> OTHER COMMENTS AND CONDITIONS <br /> <br /> 1. CALL BEFORE YOU DIG .... IT'S THE LAW. <br /> A~ENTION: Oregon law requires you to follow rules adopted <br /> by the Oregon Utility Notification Center. Those rules are <br /> set forth in OAR 952-001-0010 through OAR 952-001-0090, You <br /> may obtain copies of the rules by calling the center. <br /> (Note: The telephone number for the Oregon Utility Notifica- <br /> tion Center is (502) 232-1987). <br /> 2. THIS PLAN REVIEW WAS COMPLETED BY S, FREILINGER ON 7/1/98. <br /> 2. Approval of submitted plans is not an approval of omissions <br /> or oversights by this office or of noncompliance with any <br /> applicable regulations of local government. <br /> 4. Site grading and drainage shall provide grades which slope <br /> downward away from manufactured dwelling stands, foundation <br /> footings, concrete slabs, patios, walls, skirting, and <br /> foundations at a MINIMUM GRADE OF 1/2 INCH PER FOOT FOR 6 <br /> FEET horizontally. (Section 302(c) 1996 Oregon Manufactured <br /> Dwelling Code Standards). <br /> 5. Provide at least i square foot of underfloor ventilation <br /> for each 150 square feet of crawl space area, The openings <br /> shell be covered with a corrosion resistant wire ~sh. At <br /> least one such opening shall be provided within 3 feet of <br /> each corner of the building. (R-311.1) <br /> 6. Provide an access crawl hole to the underfloor space. The <br /> minimum size opening required is 18 inches by 24 inches, <br /> (R-311.2) <br /> 7, Stairways shall not be less than 3 feet in clear width and <br /> the headroom shall not be less than 6 feet B inches, The <br /> minimum required stair tread width is 9 inches. The <br /> maximum stair rise is 8 inches, When risers are <br /> closed, all treads may have a uniform projection not to <br /> exceed 1 and 1/2 inches. The greatest riser height shall <br /> not exceed the smallest by more than 3/8 inch, (R-215.1) <br /> 8. Handrails meeting the following reduirements shall be <br /> provided on at least one side of stairways. The handgrip <br /> <br /> <br />