LEED- Miscellaneous - Laserfiche WebLink

Home Browse Search

Points Points Credit Description Possible Scored ENHANCING INDOOR ENVIRONMENTAL QUALITY Prerequisite 1 Comply with ASHRAE Standard 62 - 1989, with the Indoor Air proviso that the ambient air quality standard requirements Quality/ shall be site specific, not region specific. Locate building Ventilation/Fresh fresh air intake away from loading areas, building exhaust Air Intakes fans, cooling towers, and other sources of contamination 0 Achieved Prerequisite 2 Prohibit smoking in all areas of the building Smoking Ban 0 Achieved Prerequisite 3 Comply with ASHRAE Standard 55 - 1992 Thermal Comfort 0 Achieved Install a permanent air monitoring system that has the capability to monitor supply and return air and ambient air Permanent Air at the fresh air intake for carbon monoxide (CO), carbon Monitoring System dioxide (C02), total volatile organic compounds (TVOCs), and particulate (including PM10) 1 Status: Variance granted by LEED Committee. Installation VOC sensors in return air ducts only. Responsibility: Architect to gather cost estimates and prepare cost proposal. Design/Development Team to decide wl:et/rer or not to install sensors. After completion of construction and prior to occupancy, Construction IAQ provision of cleaning requirements for ventilation system Management - components and pathways exposed to contamination during Level 1 construction. Prepare Construction IAQ Management plan. 1 1 Status: Necessnry reguirements to comply witfz LEED credit were not incluried in specificntions. Responsibility: General Contractor to estimate cost of complying with credit. In addition to above requirement, reduce construction contamination in the building prior to occupancy. If the return air side of the system is used during construction, provide a minimum of 85% filtration, as determined by Construction IAQ ASHRAE Standard 52.1 -1992, on return-side system Management - components during construction and replace all filtration Leve12 media prior to occupancy. 1 1 Stutus: Variance granted by LEED Committee. Install ZO% air ftlters on return-side system components and 65% at t/ie unit. Responsibiliry: General Contractor to estimate cost of complying with credit. Use of Low VOC Adhesives. At a minimum, all adhesives must meet the Materials - VOC limits of South Coast Rule # 1] 68 by the South Coast Level 1 Air Quality Management District 1* Status: Language is inc[uded in specs. Responsibility: Architect and HLA to track complianee. Use of Low VOC Architectural sealants. At a minimum, all sealants must Materials -Leve12 meet Regulation 8, Rule 51 Bay Area Air Resources Board. 1* Stntus: Laiiguage is included in specs. Responsibi[ity: Architect and HLA to track compliance. Use of Low VOC Paints and coatings. At a minimum, all paints and coatings Materials - must meet New Jersey State Department of Environmental Level 3 Protection, Title 7, Chapter 37, Subchapter 23. 1* Status: Language is included in specs. Responsibiliry: Arcltitect antl HLA to track compliance. * One point is available if one or two credits in this category are achieved. Two points are available if all three credits are achieved.